It's ok I am still around. I am not in the middle of what's become commonly known in our household as "The 110 despair cycle", nope I just have been really very busy with work and fitting life in in general.
This is literally the first time I have managed to find twenty minutes to sit down quietly by myself to write a few more ramblings.
It is getting really quite close to MOT time now after putting in a fair few hours on The 110 last week. First point of contact was taking out the faulty steering box again. With all of the practice doing this particular part of the rebuild, I am becoming quite a dab hand at it now.
So I popped the bonnet open to be faced with the popped seals unit.
This literally fell out because it has only been in there for what feels like five minutes. All the nuts and bolts came off cleanly, even the ones under the inner wing.
I was going to try and tackle the inner wing bolts with the wheels still on but it soon became clear that this was not going to happen. So the wheel was whipped off to make it a tad easier. Honestly I think I am going to wear out the wheel nuts before this build is finished with the amount of times they come on and off the motor.
With the old steering box quickly removed I went and grabbed the replacement. This is my second and final stab at using a second unit. Honestly if this one is faulty as well I will just bide my time and save up for a new bugger.
I could not remove the old steering arm that was on the box for love nor money so in the end I very very carefully cut through it as it sat on the spindles using a 1mm cutting disc. When it got near to the spindle I stopped and using a slightly thicker chisel whacked the cut open with a couple of deft blows. This released the old arm and left me with an intact usable unit.
With that done the box was quickly fitted, it needed some adjustment on the steering column arms to make it all bolt up nicely, and everything centred up steering wise once more.
I have no idea if it works or leaks yet as I have not had the chance to pop out and buy some power steering fluid. No really I haven't, the only parts I have manged to get hold of have been online. These amount to the new turbo oil feed pipe (cost a small fortune), a set of number plates and the bonnet catches.
It wont be long before these are fitted and we are then closer than ever towards getting the MOT sorted. Funds and any disasters pending I am hoping this should be within the next month or so. We can then get to the next round of breakdowns and repairs as we tackle the teething problems of the rebuild!